Alcatel-Lucent 7450 Configuration Manual page 537

integer.
range start end — an inclusive range of source or destination port values to be used as match criteria.
start of the range and end of the range are expressed as decimal integers.
port-list-name — A string of up to 32 characters of printable ASCII characters. If special characters
are used, the string must be enclosed within double quotes.
prefix
Syntax prefix ipv6-prefix/prefix-length
no prefix ipv6-prefix/prefix-length
Context config>filter>match-list>ipv6-pfx-list
Description This command adds an IPv6 address prefix to an existing IPv6 address prefix match list.
The no form of this command deletes the specified prefix from the list.
Operational notes:
To add set of different prefixes, execute the command with all unique prefixes. The prefixes are
allowed to overlap IPv6 address space.
An IPv6 prefix addition will be blocked, if resource exhaustion is detected anywhere in the system
because of Filter Policies that use this IPv6 address prefix list.
Default No prefixes are in the list by default
Parameters ipv6-prefix — A An IPv6 address prefix written as hexadecimal numbers separated by colons with
prefix-length — Length of the entered IP prefix.
prefix
Syntax prefix ip-prefix/prefix-length
no prefix ip-prefix/prefix-length
Context config>filter>match-list>ip-prefix-list
7450 ESS Router Configuration Guide
Values 0 — 65535
Values 0 — 65535
host bits set to 0. One string of zeros can be omitted so 1010::700:0:217A is equivalent to
1010:0:0:0:0:700:0:217A
Values ipv6-prefix: - IPv6 address prefix
x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0..FFFF]H
d: [0..255]D
Values 1 — 128
Filter Policies
Page 537