Modifying A Filter Policy - Alcatel-Lucent 7450 Configuration Manual

Modifying a Filter Policy

Modifying a Filter Policy
There are several ways to modify an existing filter policy. A filter policy can be modified
dynamically as part of subscriber management dynamic insertion/removal of filter policy entries
(see SROS Triple Play Guide for details). A filter policy can be modified indirectly by
configuration change to a match list the filter policy uses (as described earlier in this guide). In
addition, a filter policy can be directly edited as described below.
To access a specific IP (v4)filter, you must specify the filter ID, or if defined, filter name. Use the
form of the command to remove the command parameters or return the parameter to the default
no
setting.
Example
The following output displays the modified IP filter output:
A:ALA-7>config>filter# info
----------------------------------------------
...
Page 484
:
config>filter>ip-filter# description "New IP filter info"
config>filter>ip-filter# entry 2 create
config>filter>ip-filter>entry$ description "new entry"
config>filter>ip-filter>entry# action drop
config>filter>ip-filter>entry# match dst-ip 10.10.10.104/32
config>filter>ip-filter>entry# exit
config>filter>ip-filter#
ip-filter 11 create
description "New IP filter info"
scope exclusive
entry 1 create
match
dst-ip 10.10.10.91/24
src-ip 10.10.10.106/24
exit
action drop
exit
entry 2 create
description "new entry"
match
dst-ip 10.10.10.104/32
exit
action drop
exit
entry 10 create
match
dst-ip 10.10.10.91/24
src-ip 10.10.0.100/24
exit
action drop
exit
7450 ESS Router Configuration Guide