Alcatel-Lucent 7450 Configuration Manual page 133

enable — Static routes can be administratively enabled or disabled. Use the enable parameter to re-
disable — Static routes can be administratively enabled or disabled. Use the disable parameter to
bfd-enable — Associates the state of the static route to a BFD session between the local system and
mcast-family — Enables submission of the IPv4 or IPv6 static route into IPv4 or IPv6 multicast
cpe-check target-ip-address — This parameter specifies the IP address of the target CPE device.
interval seconds — This optional parameter specifies the interval between ICMP pings to the target
IP address.
drop-count count — This optional parameter specifies the number of consecutive ping-replies that
must be missed to declare the CPE down and to de-active the associated static route.
log — This optional parameter enables the ability to log transitions between active and in-active
Sample Output
*B:Dut-C# configure router "management"
*B:Dut-C>config>router# info
----------------------------------------------
7450 ESS Router Configuration Guide
enable a disabled static route. In order to enable a static route, it must be uniquely identified by
the IP address, mask, and any other parameter that is required to identify the exact static route.
The administrative state is maintained in the configuration file.
Default enable
disable a static route while maintaining the static route in the configuration. In order to enable a
static route, it must be uniquely identified by the IP address, mask, and any other parameter that
is required to identify the exact static route.
The administrative state is maintained in the configuration file.
Default enable
the configured nexthop. This keyword cannot be configured if the indirect or blackhole
keywords are specified. The remote end of the BFD session must also be configured to originate
or accept the BFD session controlling the static-route state.
RTM.
Values mcast-ipv4, mcast-ipv6
ICMP pings will be sent to this target IP address. This parameter must be configured to enable
the CPE connectivity feature for the associated static route. The target-ip-address cannot be in the
same subnet as the static route subnet itself to avoid possible circular references. This option is
mutually exclusive with BFD support on a given static route.
Default no cpe-check enabled
Values 1 —255 seconds
Default 1 seconds
Values 1 —255
Default 3
based on the CPE connectivity check. Events should be sent to the system log, syslog and SNMP
traps.
static-route 1.1.1.0/24 next-hop 172.31.117.1
static-route 1::/96 next-hop 3000::AC1F:7567
IP Router Configuration
Page 133