Alcatel-Lucent 7450 Configuration Manual page 520

IP (v4/v6) Filter Entry Commands
next-hop ipv6-address — The IPv6 address of the direct next-hop to which to forward matching
indirect ip-address — The IP address of the indirect next-hop to which to forward matching packets
redirect policy-name — Specifies the redirect policy configured in the config>filter>redirect-
packet-length {{lt | eq | gt} packet-length-value | range packet-length-value packet-length-
value} — - Specifies packet matching an entry will be dropped if "Total Length" field in packet's
interface ip-int-name — The name of the egress IP interface where matching packets will be
sap sap-id — Specifies the currently configured VPLS SAP. Only Ethernet SAPs are supported
sdp sdp-id:vc-id — specifies an SDP defined in the system. Refer to the 7x50 SR OS Services Guide
http-redirect url — Specifies the HTTP web address that will be sent to the user's browser. Note
that http-redirect is not supported on 7750 SR-1 or 7450 ESS-1 models.
The following displays information that can optionally be added as variables in the portal
URL (http-redirect url):
Page 520
packets in hexadecimal notation.
in dotted decimal notation. The direct next-hop IP address and egress IP interface are determined
by a route table lookup.
If the next hop is not available, then a routing lookup will be performed and if a match is found
the packet will be forwarded to the result of that lookup. If no match is found a "ICMP
destination unreachable" message is send back to the origin.
policy context.
IPv4 header or "Payload Length" field in packet's IPv6 header matches the packet-length
condition configured. Otherwise, the packet (packet matching entry condition but not packet-
length condition) will be forwarded.
Operators: lt – "less than", eq – "equal to", gt – "greater than", range - "specifies an inclusive
range" can be used to specify action execution condition. Inclusive range can be defined using
range operator.
Values packet-length-value – integers from 0 to 65535. 0 cannot be used with lt, and
65535 cannot be used with gt. When range is used, the start of the range (first value
entered) must be smaller than the end of the range (second value entered).
forwarded from. This parameter is only valid for unnumbered point-to-point interfaces. If the
string contains special characters (#, $, spaces, etc.), the entire string must be enclosed within
double quotes.
(including q-in-q, BCP, bridged Ethernet in Frame Relay or ATM). Refer to
Command Descriptions on page 523
for information about SDPs.
• $IP – The customer's IP address.
• $MAC – The customer's MAC address.
• $URL – The original requested URL.
• $SAP – The customer's SAP.
• $SUB – The customer's subscriber identification string".
for SAP CLI command syntax and parameter descriptions.
7450 ESS Router Configuration Guide
Common CLI