Alcatel-Lucent 7450 Configuration Manual page 525

dst-port
Syntax dst-port {lt | gt | eq} dst-port-number
dst-port port-list-name
dst-port range dst-port-number dst-port-number
no dst-port
Context config>filter>ip-filter>entry>match
config>filter>ipv6-filter>entry>match
Description This command configures a destination TCP, UDP, or SCTP port number or port range for an IP filter
match criterion. Note that an entry containing Layer 4 non-zero match criteria will not match non-
initial (2nd, 3rd, etc) fragments of a fragmented packet since only the first fragment contains the
Layer 4 information.
The no form of the command removes the destination port match criterion.
Default none
Parameters lt | gt | eq — Specifies the operator to use relative to dst-port-number for specifying the port number
eq — Specifies the operator to use relative to dst-port-number for specifying the port number match
dst-port-number — The destination port number to be used as a match criteria expressed as a decimal
port-list-name — A string of up to 32 characters of printable ASCII characters. If special characters
range dst-port-number dst-port-number — Specifies inclusive port range between two dst-port-
flow-label
Syntax flow-label flow-label [mask]
no flow-label
Context config>filter>ipv6-filter>entry>match
Description
This command configures the flow-label and optional mask match condition.
The no form of the command reverts to the default.
Default no flow-label
7450 ESS Router Configuration Guide
match criteria.
lt specifies all port numbers less than dst-port-number match.
gt specifies all port numbers greater than dst-port-number match.
eq specifies that dst-port-number must be an exact match.
criteria. The eq keyword specifies that dst-port-number must be an exact match.
integer.
Values 0 — 65535
are used, the string must be enclosed within double quotes.
number values.
Filter Policies
Page 525