Modifying Cflowd Collector Parameters - Alcatel-Lucent 7450 Configuration Manual

Modifying Cflowd Collector Parameters

Use the following commands to modify cflowd collector and aggregation parameters:
CLI Syntax: config>cflowd#
If a specific collector UDP port is not identified then, by default, flows are sent to port 2055.
The following displays basic cflowd modifications:
A:ALA-1>config>cflowd# info
-----------------------------------------
active-timeout 60
-----------------------------------------
A:ALA-1>config>cflowd#
7450 ESS Router Configuration Guide
collector ip-address[:port] [version version]
no collector ip-address[:port]
[no] aggregation
[no] as-matrix
[no] destination-prefix
[no] protocol-port
[no] raw
[no] source-destination-prefix
[no] source-prefix
[no] autonomous-system-type [origin | peer]
[no] description description-string
[no] shutdown
template-set {basic | mpls-ip | l2-ip}
overflow 2
rate 10
collector 10.10.10.1:2000 version 5
description "AS info collector"
exit
collector 10.10.10.2:5000 version 8
aggregation
source-prefix
raw
exit
description "Test collector"
exit
Configuring System Management with CLI
Page 633