Alcatel-Lucent 7450 Configuration Manual page 129

Parameters
multiplier — Specifies the multiplier.
type
Syntax [no] type cpm-np
Context config>router>bfd>bfd-template
Description
This command selects the CPM network processor as the local termination point for the BFD session.
This is enabled by default.
Default type cpm-np
single-sfm-overload
Syntax single-sfm-overload [holdoff-time holdoff-time]
no single-sfm-overload
Context config>router
Description This command, if enabled, will cause the OSPF for the service to enter an overload state when the
node has fewer than the full set of SFMs functioning. Once a significant amount of multicast capacity
is lost due to missing SFM(s) then the overload state will be entered.
The no form of this command causes the overload state to be cleared.
Default no single-sfm-overload
Parameters
holdoff-time — This parameter specifies the delay between the detection of a single SFM and
static-route
Syntax [no] static-route {ip-prefix/prefix-length | ip-prefix netmask} [preference preference]
[metric metric] [tag tag] [community comm-id] [enable | disable] next-hop ip-int-name | ip-
address [mcast-family] [bfd-enable |{cpe-check cpe-ip-address [interval seconds] [drop-
count count] [log]} {prefix-list prefix-list-name [all | none]} |{fc fc-name [priority {low |
high}]} ] [ldp-sync] [validate-next-hop]
[no] static-route {ip-prefix/prefix-length | ip-prefix netmask} [preference preference]
[metric metric] [tag tag] [community comm-id] [enable | disable] indirect ip-address [cpe-
check cpe-ip-address [interval seconds] [drop-count count] [log]] {prefix-list prefix-list-
name [all | none]} |{fc fc-name [priority {low | high}]}
7450 ESS Router Configuration Guide
Values 3 — 20, integers
Default 3
enacting the overload state.
Values
1— 600 seconds
Default 0 seconds
IP Router Configuration
Page 129