Alcatel-Lucent 7450 Configuration Manual page 543

Parameters ieee-address — The MAC address to be used as a match criterion.
mask — A 48-bit mask to match a range of MAC address values.
etype
Syntax etype ethernet-type
no etype
Context config>filter>mac-filter>entry
Description
Configures an Ethernet type II Ethertype value to be used as a MAC filter match criterion.
The Ethernet type field is a two-byte field used to identify the protocol carried by the Ethernet frame.
For example, 0800 is used to identify the IPv4 packets.
The Ethernet type field is used by the Ethernet version-II frames. IEEE 802.3 Ethernet frames do not
use the type field. For IEEE 802.3 frames, use the dsap, ssap or snap-pid fields as match criteria.
The snap-pid field, etype field, ssap and dsap fields are mutually exclusive and may not be part of the
same match criteria.
The no form of the command removes the previously entered etype field as the match criteria.
Default no etype
Parameters ethernet-type — The Ethernet type II frame Ethertype value to be used as a match criterion expressed
7450 ESS Router Configuration Guide
Values HH:HH:HH:HH:HH:HH or HH-HH-HH-HH-HH-HH where H is a hexadecimal
digit
This 48-bit mask can be configured using the following formats:
Format Style
Decimal
Hexadecimal
Binary
To configure so that all packets with a source MAC OUI value of 00-03-FA are subject to a
match condition then the entry should be specified as: 0003FA000000 0x0FFFFF000000
Default 0xFFFFFFFFFFFF (exact match)
Values 0x00000000000000 — 0xFFFFFFFFFFFF
in hexadecimal.
Values 0x0600 — 0xFFFF
Format Syntax
DDDDDDDDDDDDDD
0xHHHHHHHHHHHH
0bBBBBBBB...B
Filter Policies
Example
281474959933440
0xFFFFFF000000
0b11110000...B
Page 543