Alcatel-Lucent 7450 Configuration Manual page 554

Redirect Policy Commands
url-test
Syntax url-test test-name
Context config>filter>redirect-policy>destination
Description
The context to enable URL test parameters. IP filters can be used to selectively cache some web
sites.
Default none
Parameters test-name — The name of the URL test. Allowed values are any string up to 32 characters long
return-code
Syntax return-code return-code-1 [return-code-2] [disable | lower-priority priority | raise-priority
priority]
no return-code return-code-1 [return-code-2]
Context config>filter>redirect-policy>destination>url-test
Description Return codes are returned when the URL test is performed. Values for the specified range are the
return codes which can be given back to the system as a result of the test been performed.
For example, error code 401 for HTTP is "page not found." If, while performing this test, the URL is
not reachable, you can lower the priority by 10 points so that other means of reaching this destination
are prioritized higher than the older one.
Default none
Parameters return-code-1, return-code-2 — Specifies a range of return codes. When the URL test return-code
falls within the specified range, the corresponding action is performed.
disable — Specifies that the destination may not be used for the amount of time specified in the
lower-priority priority — Specifies the amount to lower the priority of the destination when the
raise-priority priority — Specifies the amount to raise the priority of the destination when the return
Page 554
composed of printable, 7-bit ASCII characters. If the string contains special characters (#, $,
spaces, etc.), the entire string must be enclosed within double quotes.
Values return-code-1:
return-code-2:
hold-time command when the return code falls within the specified range.
return code falls within the specified range.
code falls within the specified range.
1 — 4294967294
2 — 4294967295
7450 ESS Router Configuration Guide