Alcatel-Lucent 7450 Configuration Manual page 553

Default none
Parameters
oid-string — Specifies the object identifier (OID) in the OID field.
community community-string — The SNMP v2 community string or the SNMP v3 context name
used to conduct this SNMP test.
return-value
Syntax return-value return-value type return-type [disable | lower-priority priority | raise-priority
priority]
Context config>filter>redirect-policy>destination>snmp-test
Description This command specifies the criterion to adjust the priority based on the test result. Multiple criteria
can be specified with the condition that they are not conflicting or overlap. If the returned value is
within the specified range, the priority can be disabled, lowered or raised.
Default none
Parameters return-value — Specifies the SNMP value against which the test result is matched.
return-type — Specifies the SNMP object type against which the test result is matched.
disable — The keyword that specifies that the destination may not be used for the amount of time
lower-priority priority — Specifies the amount to lower the priority of the destination.
raise-priority priority — Specifies the amount to raise the priority of the destination.
unicast-rt-test
Syntax [no] unicast-rt-test
Context config>filter>redirect-policy>destination
Description This command configures a unicast route test for this destination. A destination is eligible for redirect
if a valid unicast route to that destination exists in the RTM for the specified router command
instance. The unicast route test is mutually exclusive with other redirect-policy test types.
The test cannot be configured if no router is configured for this redirect policy.
The no form of the command disables the test.
Default no unicast-rt-test
7450 ESS Router Configuration Guide
Values A maximum of 256 characters.
Values integer, unsigned, string, ip-address, counter, time-ticks, opaque
specified in the hold-time command when the test result matches the criterion.
Values 1 — 255
Values 1 — 255
Filter Policies
Page 553