Redirect Policy Commands - Alcatel-Lucent 7450 Configuration Manual

Redirect Policy Commands

Redirect Policy Commands
destination
Syntax destination ip-address [create]
no destination ip-address
destination ipv6-address [create]
no destination ipv6-address
Context config>filter>redirect-policy
Description This command defines a destination in a redirect policy. More than one destination can be
configured. Whether a destination IPv4/IPv6 address will receive redirected packets depends on the
effective priority value after evaluation.
The most preferred destination is programmed in hardware. If all destinations are down (as
determined by the supported tests), action forward is programmed in hardware. All destinations
within a given policy must be either IPv4 or (exclusive) IPv6. The redirect policy with IPv4
destinations configured can only be used by IP filter policies. The redirect policy with IPv6
destinations configured can only be used by IPv6 filter policies.
Default no destination
Parameters ip-address — Specifies the IPv4 address to send the redirected traffic.
ipv6-address — Specifies the IPv6 address to send the redirected traffic.
ping-test
Syntax [no] ping-test
Context config>filter>destination>ping-test
config>filter>destination>snmp-test
Description This command configures parameters to perform connectivity ping tests to validate the ability for the
destination to receive redirected traffic.
Default none
Page 550
Values ip-address: a.b.c.d
Values
ipv6-address: x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x::d.d.d.d
x: [0..FFFF]H
d: [0..255]D
7450 ESS Router Configuration Guide