Alcatel-Lucent 7450 Configuration Manual page 532

IP (v4/v6) Filter Entry Commands
src-port
Syntax src-port {lt | gt | eq} src-port-number
src-port port-list port-list-name
src-port range src-port-number src-port-number
no src-port
Context config>filter>ip-filter>entry>match
config>filter>ipv6-filter>entry>match
Description This command configures a source TCP, UDP, or SCTP port number, port range, or port match list for
an IP filter match criterion. Note that an entry containing Layer 4 non-zero match criteria will not
match non-initial (2nd, 3rd, etc) fragments of a fragmented packet since only the first fragment
contains the Layer 4 information.
The no form of the command removes the source port match criterion.
Default no src-port
Parameters lt | gt | eq — Specifies the operator to use relative to src-port-number for specifying the port number
src-port-number — The source port number to be used as a match criteria expressed as a decimal
port-list-name — A string of up to 32 characters of printable ASCII characters. If special characters
range src-port-number src-port-number — Specifies inclusive port range between two src-port-
src-route-option
Syntax src-route-option {true|false}
no source-route-option
Context config>filter>ip-filter>entry>match
Description This command enables source route option match conditions. When enabled, this filter should match
if a (strict or loose) source route option is present/not present at any location within the IP header, as
per the value of this object.
Parameters true — Enables source route option match conditions.
false — Disables source route option match conditions.
Page 532
match criteria.
lt specifies all port numbers less than src-port-number match.
gt specifies all port numbers greater than src-port-number match.
eq specifies that src-port-number must be an exact match.
integer.
Values 0 — 65535
are used, the string must be enclosed within double quotes. <<R12.0>>
number values.
7450 ESS Router Configuration Guide