Filter Policy Commands - Alcatel-Lucent 7210 SAS M Configuration Manual

Configuration Commands

Filter Policy Commands

default-action
Syntax default-action {drop | forward}
Context config>filter>ip-filter
config>filter>mac-filter
Description This command specifies the action to be applied to packets when the packets do not match the
specified criteria in all of the IP filter entries of the filter.
When multiple default-action commands are entered, the last command will overwrite the previous
command.
Default
drop
Parameters
drop — Specifies all packets will be dropped unless there is a specific filter entry which causes the
forward — Specifies all packets will be forwarded unless there is a specific filter entry which causes
scope
Syntax scope {exclusive | template}
no scope
Context config>filter>ip-filter
config>filter>mac-filter
Description
This command configures the filter policy scope as exclusive or template. If the scope of the policy is
template and is applied to one or more services or network interfaces, the scope cannot be changed.
The no form of the command sets the scope of the policy to the default of template.
Default template
Parameters
exclusive — When the scope of a policy is defined as exclusive, the policy can only be applied to a
template — When the scope of a policy is defined as template, the policy can be applied to multiple
Page 128
packet to be forwarded.
the packet to be dropped.
single entity (SAP or network IP interface). Attempting to assign the policy to a second entity
will result in an error message. If the policy is removed from the entity, it will become available
for assignment to another entity.
SAPs or network IP interfaces.
7210 SAS M, X Router Configuration Guide