Setup Confirmation; Calling The Maintenance - Konica Minolta bizhub C353 Service Manual

10. Service Mode
10.7.4

Setup confirmation

• Follow the steps below to make sure that CS Remote Care has been properly set
up.
1. Call the Service Mode to the screen.
2. Touch [CS Remote Care].
3. Check to make sure that only selected item is displayed.
10.7.5

Calling the maintenance

• When CE starts maintenance, inputting the ID code of CE (seven digits: numbers which
CE can identify. They are controlled by the distributor.) will transmit the information to the
Center side and tells that the maintenance has started. When the maintenance is fin-
ished, touching [Maintenance Complete] key will transmit the information to the center
and tells that it is finished.
A. When starting the maintenance
1. Select Service Mode and touch [CS Remote Care].
2. Touch [ID Code], and input ID Code.
3. Touch [ID Coke].
* The Start key blinks while maintenance is being carried out.
B. When finishing the maintenance
1. Select Service Mode and touch [CS Remote Care].
2. Touch [Maintenance Complete].
376
Field Service Ver. 3.0 Jan. 2008