Health Threshold - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

health threshold

Configures thresholds for input traffic (RX), output/input traffic (TX/RX), memory usage, CPU usage, and
chassis temperature.
Input traffic, output/input traffic, memory usage, and CPU usage thresholds specify the maximum percent-
age for each resource that may be consumed before a trap is sent to the user. The temperature threshold
specifies the maximum operating temperature, in Celsius, allowed within the chassis before a trap is sent.
health threshold {rx percent | txrx percent | memory percent | cpu percent | temperature degrees}
Syntax Definitions
rx
txrx
memory
cpu
percent
temperature
degrees
Defaults
parameter
percentage
degrees
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
When a resource falls back below the configured threshold, an additional trap is sent to the user. This
indicates that the resource is no longer operating beyond its configured threshold limit.
•
Changing a threshold value sets the value for all levels of the switch (i.e., switch, module, and port).
You cannot set different threshold values for each level.
•
For detailed information on each threshold type, refer to
Problems" chapter in the OmniSwitch 6250 Network Configuration Guide.
•
To view the current health threshold values, use the
show temperature
commands are unrelated.
page 36-2
Specifies the maximum input (RX) traffic threshold.
Specifies the maximum output/input (TX/RX) traffic threshold.
Specifies the maximum RAM memory usage threshold.
Specifies the maximum CPU usage threshold.
The new threshold value, in percent, for the corresponding resource—
i.e., rx, txrx, memory, cpu—(0–100).
Specifies the temperature threshold for the chassis.
The new threshold value, in Celsius, for the chassis temperature
threshold (0–100).
default
80
50
command as it does not display health threshold statistics. These two show
page 36-6, or refer to the "Diagnosing Switch
show health threshold
OmniSwitch 6250 CLI Reference Guide
Health Monitoring Commands
command. Do not use the
November 2009