Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 1518

•
The command options offer alternate ways of configuring TCP or UDP ports for a service. Note that
port types (TCP or UDP) cannot be mixed in the same service. The following table shows how the
keywords are used:
To configure:
TCP or UDP ports for a service
TCP ports for a service
UDP ports for a service
•
If the snapshot command is entered after the policy service command is configured, the resulting
ASCII file will include the following additional syntax for the policy service command:
from {cli | ldap | blt}
This syntax indicates how the service was created. The cli and ldap options may be changed by a user
modifying the ASCII file; however, changing this setting is not recommended. The blt option indicates
a built-in object, this setting is not configurable.
Examples
The following two commands show two different ways of configuring the same service:
-> policy service telnet2 protocol 6 destination ip port 23
-> policy service telnet3 destination tcp port 23
Release History
Release 6.6.1; command was introduced.
Related Commands
policy service group
policy condition
qos apply
show policy service
page 39-22
Use keywords:
protocol
source ip port
destination ip port
source tcp port
destination tcp port
source udp port
destination udp port
Configures a policy service group, which is made up of policy services.
Creates a policy condition.
Applies configured QoS and policy settings to the current configuration.
Displays information about policy services configured on the switch.
OmniSwitch CLI Reference Guide
QoS Policy Commands
Notes
The protocol must be specified with
at least one source or destination
port.
Keywords may be used in
combination.
Keywords may be used in
combination.
November 2009