Ip Router-Discovery Interface - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

RDP Commands

ip router-discovery interface

Enables or disables RDP for the specified IP interface. An RDP interface is created for the specified IP
interface name, which is then advertised by RDP as an active router on the local network.
ip router-discovery interface name [enable | disable]
no router-discovery interface name
Syntax Definitions
name
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of this command to remove the RDP interface from the switch configuration.
•
Do not use the enable option the first time this command is used to create an RDP interface, as it is not
necessary and will return an error message. Once RDP is enabled and then is subsequently disabled,
however, the enable option is then required the next time this command is used to enable the RDP
interface.
•
The RDP interface is not active unless RDP is also enabled for the switch.
Examples
-> ip router-discovery interface Marketing
-> ip router-discovery interface Marketing disable
-> ip router-discovery interface Marketing enable
-> no ip router-discovery interface Marketing
Release History
Release 6.6.1; command was introduced.
OmniSwitch 6250 CLI Reference Guide
The IP interface name that was defined at the time the IP interface was
configured.
Enables an RDP interface for the specified IP interface.
Disables an RDP interface for the specified IP interface.
default
enable
November 2009 page 31-3