Show Ipv6 Neighbors - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

show ipv6 neighbors

Displays IPv6 Neighbor Table.
show ipv6 neighbors [ipv6_prefix/prefix_length | if_name | hw hardware_address | static]
Syntax Definitions
ipv6_prefix/prefix_length
if_name
hardware_address
static
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
If you do not specify an option (e.g., if_name), all IPv6 neighbors are displayed.
Examples
-> show ipv6 neighbors
IPv6 Address
----------------------------+-------------------+----------+-------+-----+---------
fe80::02d0:c0ff:fe86:1207
fe80::020a:03ff:fe71:fe8d
output definitions
IPv6 Address
Hardware Address
State
Type
Port
Interface
page 30-36
IPv6 prefix. Restricts the display to those neighbors starting with the
specified prefix.
Interface name. Restricts the display to those neighbors reached via the
specified interface.
MAC address. Restricts the display to the specified MAC address.
Restricts display to statically configured neighbors.
Hardware Address
00:d0:c0:86:12:07
00:0a:03:71:fe:8d
The neighbor's IPv6 address.
The MAC address corresponding to the IPv6 address.
The neighbor's state:
- Unknown
- Incomplete
- Reachable
- Stale
- Delay
- Probe.
Indicates whether the neighbor entry is a Static or Dynamic entry.
The port used to reach the neighbor.
The neighbor's interface name (e.g., vlan_1)
OmniSwitch 6250 CLI Reference Guide
State Type Port
Probe Dynamic 1/15
Reachable Dynamic 1/ 5
IPv6 Commands
Interface
vlan_4
vlan_17
November 2009