Show Ipv6 Routes - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

IPv6 Commands

show ipv6 routes

Displays IPv6 Forwarding Table.
show ipv6 routes [ipv6_prefix/prefix_length | static]
Syntax Definitions
ipv6_prefix/prefix_length
static
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
If you do not specify an option (e.g., "static"), all IPv6 interfaces are displayed.
Examples
-> show ipv6 routes
Legend:Flags:U = Up, G = Gateway, H = Host, S = Static, C = Cloneable, D = Dynamic,
M = Modified, R = Unreachable, X = Externally resolved, B = Discard,
L = Link-layer, 1 = Protocol specific, 2 = Protocol specific
Destination Prefix
-------------------+----------------+--------+-----------------+------------+---------+-----
195:35::/64
212:95:5::/64
output definitions
Destination Prefix
Gateway Address
Interface
Age
Protocol
OmniSwitch 6250 CLI Reference Guide
IPv6 prefix. Restricts the display to those routes starting with the speci-
fied prefix.
Restricts display to statically configured routes.
Gateway Address
fe80::2d0:95ff:fe12:f470
fe80::2d0:95ff:fe12:f470
IPv6 destination address and prefix.
IPv6 address of the gateway used to reach the destination network.
The IPv6 interface name or loopback.
Age of the entry. Entries less than 1 day old are displayed in hh:mm:ss
format. Entries more than 1 day old are displayed in dd:hh format.
Protocol by which the route was learned.
November 2009
Interface Age
v6if-to-eagle 18h 51m 55s
smbif-5 18h 51m 55s
Protocol Flags
Local UC
Local UC
page 30-41