Traceroute6 - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

IPv6 Commands

traceroute6

Finds the path taken by an IPv6 packet from the local switch to a specified destination. This command
displays the individual hops to the destination as well as some timing information.
traceroute6 {ipv6_address | hostname} [if_name] [max-hop hop_count] [wait-time time] [port
port_number] [probe-count probe]
Syntax Definitions
ipv6_address
hostname
if_name
hop_count
time
port
probe
Defaults
parameter
hop_count
time
probe
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
When using this command, you must enter the name of the destination as part of the command line
(either the IPv6 address or hostname).
•
Use the optional max-hop parameter to set a maximum hop count to the destination. If the trace
reaches this maximum hop count without reaching the destination, the trace stops.
Examples
-> traceroute6 41EA:103::65C3
Release History
Release 6.6.1; command was introduced.
OmniSwitch 6250 CLI Reference Guide
Destination IPv6 address. IPv6 address of the host whose route you
want to trace.
DNS name of the host whose route you want to trace.
If the target is a link-local address, the name of the interface used to
reach it.
Maximum hop count for the trace.
Delay time, in seconds between probes
Specific UDP port destination. By default, the destination port is chosen
by traceroute6.
Number of probes to be sent to a single hop.
default
30
5
3
November 2009 page 30-23