Show Ip Protocols - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

show ip protocols

Displays switch routing protocol information and status.
show ip protocols
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
This command also displays the switch's primary IP address and router ID, if configured, and debug infor-
mation.
Examples
-> show ip protocols
Router ID
Primary addr
RIP status
Debug level
Debug sections
output definitions
Router ID
Primary addr
RIP status
Debug level
Debug sections
Release History
Release 6.6.1; command was introduced.
page 29-96
= 10.255.11.243,
= 10.255.11.243,
= Not Loaded,
= 1,
= error,
The set routing ID. The router ID is how the router is identified in IP.
The primary interface address the route uses.
Whether RIP is loaded or not.
What the current router debug level is.
What types of debugging information are being tracked.
OmniSwitch 6250 CLI Reference Guide
IP Commands
November 2009