Qos - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

Hide thumbs Also See for OmniSwitch 6250:

Table of Contents

QoS Commands

qos

Enables or disables QoS. This section describes the base command with a single required option (enable

or disable).

In lieu of these options, the base command (qos) may be used with other keywords to set up global QoS

configuration. These keywords are listed here and described as separate commands later in this chapter. In

addition, some keywords have a no form to remove the parameter or return it to its default.

qos {enable | disable}

[trust ports]

[default servicing mode]

[forward log]

[log console]

[log lines lines]

[log level level]

[default bridged disposition {accept | deny | drop}]

[default multicast disposition {accept | deny | drop}]

[stats interval seconds]

[user-port {filter | shutdown} {spoof | bpdu | rip |}

Syntax Definitions

enable | disable

Platforms Supported

OmniSwitch 6250

Usage Guidelines

When QoS is disabled, flows coming into the switch are classified but not matched to a policy. Traffic

is treated as best effort and assigned to default queues.

The command keywords may be used with or without enable; these keywords cannot be used with

OmniSwitch CLI Reference Guide

Enables QoS. The QoS software in the switch classifies flows coming

into the switch to attempt to match them to QoS policies. If a match is

found, the policy parameters are applied to the flow. The enable setting

may be used alone or in conjunction with optional command keywords.

Disables QoS. Flows coming into the switch are not matched to poli-

cies. The disable setting cannot be used with any other command

November 2009