Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 1492

output definitions
QoS Configuration
Default queues
Default queue service
Trusted Ports
NMS Priority
Phones
Default bridged disposition
Default IGMP/MLD disposi-
tion
Log lines
Log level
Log to console
Forward log
Stats interval
Filter
Shutdown
Debug
Release History
Release 6.6.1; command was introduced.
page 38-64
Whether or not QoS is enabled or disabled. Configured through the
command.
The number of default queues for QoS ports. There are eight queues for
each QoS port; this value is not configurable.
The default servicing mode for the switch (strict-priority, WRR, or
DRR). Configured through the
The default trusted mode for switch ports. Configured through the
trust ports command.
Whether or not the automatic prioritization of NMS traffic is enabled or
disabled. Configured through the
Whether or not IP Phone traffic is automatically trusted or assigned a
priority value. Configured through the
Whether or not bridged traffic that does not match any policy will be
accepted or denied on the switch Configured through the
bridged disposition command.
Whether or not multicast flows that do not match any policy will be
accepted or denied on the switch. Configured through the
multicast disposition command.
The number of lines included in the QoS log. Configured through the
qos log lines command.
The level of log detail. Configured through the
Whether or not log messages are sent to the console. Configured
through the qos log console
Whether or not logged events are sent to the policy server software in
the switch in real time. Configured through the
mand.
How often the switch polls network interfaces for statistics about QoS
events. Configured through the
The type of traffic that is filtered on ports that are members of the User-
Ports group. Configured through the
The type of traffic that will trigger an administrative shutdown of the
port if the port is a member of the UserPorts group. Configured through
the qos user-port command.
The type of information that will be displayed in the QoS log. Config-
ured through the debug qos
default debugging type.
OmniSwitch CLI Reference Guide
qos default servicing mode
qos nms priority command.
qos phones command.
qos log level
command.
qos forward log
qos stats interval command.
qos user-port command.
command. A value of info indicates the
QoS Commands
qos
command.
qos
qos default
qos default
command.
com-
November 2009