Debug Qos Internal - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

debug qos internal

Displays debugging information for QoS internal to the switch.
debug qos internal [slice slot/slice] [flow] [queue] [port] [l2tree] [l3tree] [vector] [pending] [verbose]
[mapper] [pool] [log] [pingonly | nopingonly]
Syntax Definitions
slot/slice
flow
queue
port
l2tree
l3tree
vector
pending
verbose
mapper
pool
log
pingonly
nopingonly
Defaults
Debugging is disabled by default.
parameter
pingonly | nopingonly
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Use the debug qos command to set the level of log detail in the QoS log.
page 38-26
The slot number and slice for which you want to view debugging infor-
mation. A slice is a logical section of hardware that corresponds to
particular ports on a network interface module.
Displays information about QoS flows.
Displays information about QoS queues.
Displays information about QoS ports.
Displays information about Layer 2 flows.
Displays information about Layer 3 flows.
Displays information about vectors.
Displays information about pending QoS objects.
Sets the output to verbose mode for more detailed information.
Displays information about QoS mapping flows to queues.
Displays information about the buffer pool.
Displays information about QoS information that is logged.
On an OmniSwitch 6624/6648, specifies that any policies configured
with an ICMP protocol condition apply only to ICMP echo-requests.
Configures the switch so that any policies configured with an ICMP
protocol condition apply to any ICMP packets.
default
nopingonly
OmniSwitch CLI Reference Guide
QoS Commands
November 2009