IPv6 Commands
show ipv6 interface
Displays IPv6 Interface Table.
show ipv6 interface [if_name | loopback]
Syntax Definitions
if_name
loopback
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
If you do not specify an interface name, all IPv6 interfaces are displayed.
•
Specify an interface name (e.g., VLAN 12) to obtain a more detailed information about a specific inter-
face.
Examples
-> show ipv6 interface
Name
--------------------+----------------------------------------+---------+--------
smbif-5
v6if-to-eagle
loopback
output definitions
Name
IPv6 Address/Prefix Length
Status
Device
-> show ipv6 interface smbif-5
smbif-5
IPv6 interface index
OmniSwitch 6250 CLI Reference Guide
Interface name. Limits the display to a specific interface.
Limits display to loopback interfaces.
IPv6 Address/Prefix Length
fe80::2d0:95ff:fe12:f470/64
212:95:5::35/64
212:95:5::/64
fe80::2d0:95ff:fe12:f470/64
195:35::35/64
195:35::/64
::1/128
Interface name. This is usually the VLAN on which the interface is
configured.
IPv6 address and prefix length assigned to the interface. If an interface
has more than one IPv6 address assigned to it, each address is shown on
a separate line.
Interface status (e.g., Active/Inactive).
The device on which the interface is configured (e.g., VLAN 955).
= 16777216(0x01000000)
November 2009
Status
Device
Active
VLAN 955
Disabled
VLAN 1002
Active
loopback
page 30-29