Show Ip Router-Discovery - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

RDP Commands

show ip router-discovery

Displays the current RDP status and related statistics for the entire switch.
show ip router-discovery
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Each time RDP is enabled on the switch, all statistic parameter values are reset to zero for the new
session. For example, if the RDP uptime was 160000 seconds when RDP was last disabled, the uptime
starts out at zero the next time RDP is enabled.
•
Use the show ip router-discovery interface command to display information about a specific RDP
interface.
Examples
-> show ip router-discovery
Status
RDP uptime
#Packets Tx
#Packets Rx
#Send Errors
#Recv Errors
output definitions
Status
RDP uptime
#Packets Tx
#Packets Rx
#Send Errors
#Recv Errors
OmniSwitch 6250 CLI Reference Guide
= Enabled,
= 161636 secs
= 4,
= 0,
= 0,
= 0,
The status of RDP. Enabled allows RDP interfaces to advertise router
IP addresses; Disabled stops RDP traffic on all switch interfaces. Use
the ip router-discovery
switch.
Indicates the amount of time, in seconds, that RDP has remained active
on the switch.
The number of RDP packets transmitted from all active RDP interfaces
on the switch.
The number of RDP packets received on all active RDP interfaces on
the switch.
The number of RDP packet transmission errors that have occurred.
The number of errors that occurred when receiving RDP packets.
November 2009
command to enable or disable RDP on the
page 31-15