Ipv6 Rip Jitter - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

ipv6 rip jitter

Configures an offset value for RIPng updates. This is the maximum (positive or negative) value that can
be used to offset the update interval. For example, with an update interval of 30 seconds, and a jitter value
of 5 seconds, the RIPng update packet would be sent somewhere (random) between 25 and 35 seconds
from the previous update.
ipv6 rip jitter value
Syntax Definitions
value
Defaults
parameter
value
Platforms Supported
OmniSwitch 6250
Usage Guidelines
As you increase the number of RIPng interfaces/peers, it is recommended that you increase the Jitter value
to reduce the number of RIPng updates being sent over the network.
Examples
-> ipv6 rip jitter 10
Release History
Release 6.6.1; command was introduced.
Related Commands
ipv6 rip update-interval
show ipv6 rip
MIB Objects
alaProtocolripng
alaRipngJitter
page 30-70
Time, in seconds, that a routing update is offset. Valid range is 0 to one-
half the updated interval value (e.g., if the updated interval is 30, the
range would be 0 - 300).
default
5
Configures the RIPng update interval.
Displays RIPng status and general configuration information.
OmniSwitch 6250 CLI Reference Guide
IPv6 Commands
November 2009