Ipv6 Rip Interface Metric - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

ipv6 rip interface metric

Configures the RIPng metric or cost for a specified interface. You can set priorities for routes generated by
a switch by assigning a metric value to routes generated by that switch's RIPng interface. For example,
routes generated by a neighboring switch may have a hop count of 1. However, you can lower the priority
of routes generated by that switch by increasing the metric value for routes generated by the RIPng inter-
face.
ipv6 rip interface if_name metric value
Syntax Definitions
if_name
value
Defaults
parameter
value
Platforms Supported
OmniSwitch 6250
Usage Guidelines
When you configure a metric for a RIPng interface, this metric cost is added to the metric of the incoming
route.
Examples
-> ipv6 rip Test_Lab metric 1
Release History
Release 6.6.1; command was introduced.
Related Commands
ipv6 rip interface
show ipv6 rip interface
MIB Objects
alaRipngInterfaceTable
alaRipngInterfaceMetric
page 30-76
IPv6 interface name.
Metric value. Valid range is 1 - 15.
default
1
Creates or deletes a RIPng interface.
Displays information for all or specified RIPng interfaces.
OmniSwitch 6250 CLI Reference Guide
IPv6 Commands
November 2009