Ip Dos Scan Close-Port-Penalty - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

IP Commands

ip dos scan close-port-penalty

Assigns a penalty value to be added to the Denial of Service penalty scan value when a TCP or UDP
packet is received on a closed port.
ip dos scan close-port-penalty penalty_value
Syntax Definitions
penalty_value
Defaults
parameter
penalty_value
Platforms Supported
OmniSwitch 6250
Usage Guidelines
This command creates a point value that is added to the total port scan penalty value when a TCP or UDP
packet is received that is destined for a closed port.
Examples
-> ip dos scan close-port-penalty 25
Release History
Release 6.6.1; command was introduced.
Related Commands
ip dos scan threshold
ip dos trap
MIB Objects
alaDoSConfig
alaDoSPortScanClosePortPenalty
OmniSwitch 6250 CLI Reference Guide
A penalty value added to the penalty scan value. This value can be any
non-negative integer.
default
10
Sets the threshold for the port scan value, at which a DoS attack is
recorded.
Sets whether the switch generates SNMP DoS traps when an attack
is detected.
November 2009 page 29-71