Ipv6 Rip Holddown-Timer - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

IPv6 Commands

ipv6 rip holddown-timer

Configures the amount of time a route is placed in a holddown state. Whenever a route is seen from the
same gateway with a higher metric than the route in RIB, the route goes into holddown. This excludes
route updates with an INFINITY metric.
ipv6 rip holddown-timer seconds
Syntax Definitions
seconds
Defaults
parameter
seconds
Platforms Supported
OmniSwitch 6250
Usage Guidelines
While in holddown, the route continues being announced as usual and used in RIB. This interval is used to
control route flap dampening.
Examples
-> ipv6 rip holddown-timer 60
Release History
Release 6.6.1; command was introduced.
Related Commands
ipv6 rip invalid-timer
ipv6 rip garbage-timer
MIB Objects
alaProtocolripng
alaRipngHolddownTimer
OmniSwitch 6250 CLI Reference Guide
Time, in seconds, that a route will remain in a holddown state. Valid
range is 0 - 120.
default
0
Configures the amount of time a route remains active in RIB before
being moved to the "Garbage" state.
Configures the RIPng garbage timer value.
November 2009 page 30-69