Ipv6 Rip Triggered-Sends - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

IPv6 Commands

ipv6 rip triggered-sends

Configures the behavior of triggered updates.
ipv6 rip triggered-sends {all | updated-only | none}
Syntax Definitions
all
updated-only
none
Defaults
parameter
all | updated-only | none
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
If set to all, all routes are sent in the update, not just route changes, which increases RIPng traffic on
the network.
•
If set to none, no triggered updates are sent, which can cause delays in network convergence.
Examples
-> ipv6 rip triggered-sends none
Release History
Release 6.6.1; command was introduced.
Related Commands
show ipv6 rip
MIB Objects
alaProtocolripng
alaRipngTriggeredSends
OmniSwitch 6250 CLI Reference Guide
All RIPng routes are added to any triggered updates.
Only route changes that are causing the triggered update are included in
the update packets.
RIPng routes are not added to triggered updates.
default
updated-only
Displays RIPng status and general configuration information.
November 2009 page 30-73