Qos Port Maximum Ingress-Bandwidth - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

qos port maximum ingress-bandwidth

Configures the maximum rate at which traffic is received on a QoS port.
qos port slot/port maximum ingress-bandwidth bps
qos port slot/port no maximum ingress-bandwidth
Syntax Definitions
slot/port
bps
Defaults
By default, the maximum bandwidth is the maximum allowed for the interface type on which the port
resides.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of this command to remove a configured maximum ingress bandwidth value from a
port.
•
The maximum ingress bandwidth value cannot exceed the maximum bandwidth of the interface type
associated with the port.
•
Modifying the maximum ingress bandwidth is most useful for low-bandwidth links.
Examples
-> qos port 3/1 maximum ingress-bandwidth 1000
-> qos port 3/1 no maximum ingress-bandwidth
Release History
Release 6.6.1; command introduced.
Related Commands
qos port maximum egress-
bandwidth
qos apply
qos port
show qos port
page 38-46
The slot number and port number of the physical port.
The maximum amount of bandwidth that may be used for all traffic
ingressing on the QoS port.
Configures the rate at which traffic is sent on a QoS port.
Applies configured QoS and policy settings to the current configuration.
Configures a physical port for QoS.
Displays information about QoS ports.
OmniSwitch CLI Reference Guide
QoS Commands
November 2009