ra-default-lifetime time
enable | disable
ra-send-mtu
Defaults
parameter
ra-send
ra-max-interval
ra-managed-config-flag
ra-reachable-time
ra-retrans-timer
ra-default-lifetime
ra-send-mtu
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of this command to delete an interface.
•
When you create an IPv6 interface, it is enabled by default.
•
All IPv6 interfaces must have a name.
•
When creating an IPv6 interface you must specify a VLAN ID. When modifying or deleting an inter-
face, you do not need to specify one of these options unless the name assigned to the interface is being
changed. If it is present with a different value from when the interface was created, the command will
be in error.
•
To enable IPv6 routing you must first create a VLAN, then create an IPv6 interface on the VLAN. See
Chapter 22, "VLAN Management Commands,"
page 30-4
Value, in seconds, to be placed in the router lifetime field in router
advertisements sent on this interface. The time must be zero or between
the value of "ra-max-interval" and 9,000 seconds. A value of zero indi-
cates that the router is not to be used as a default router. The "no ra-
default-lifetime" option will calculate the value using the formula (3 *
ra-max-interval).
Administratively enable or disable the interface.
Specifies whether the MTU option is included in the router advertise-
ments sent on the interface.
default
yes
600
false
0
0
no
no
for information on creating VLANs.
OmniSwitch 6250 CLI Reference Guide
IPv6 Commands
November 2009