Qos Phones - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

qos phones

Enables or disables the automatic prioritization of IP phone traffic.
qos phones priority priority_value
qos no phones
Syntax Definitions
priority_value
Defaults
By default, the priority value is set to 5.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of this command to disable automatic prioritization of IP phone traffic.
•
IP phone traffic is identified by examining the source MAC address of the packet received on the port.
If the source MAC falls within one of the following ranges, the QoS IP phone priority is automatically
assigned to the MAC:
00-80-9F-54-xx-xx to 00-80-9F-64-xx-xx
00-80-9F-66-xx-xx to 00-80-9F-6F-xx-xx.
•
To automatically apply the QoS IP phone priority to other, non-IP phone traffic, add the source MAC
addresses of such traffic to the QoS "alaPhone" group.
•
When automatic prioritization of IP phone traffic is enabled, QoS policies that specify priority are not
applied to the IP phone traffic. Other QoS policies, however, are applied to this type of traffic as usual.
Examples
-> qos phones priority 7
-> qos no phones
Release History
Release 6.6.1; command was introduced.
page 38-20
The priority given to scheduling traffic on the output port. Values range
from 0 (lowest) to 7 (highest).
OmniSwitch CLI Reference Guide
QoS Commands
November 2009