Debug Qos - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

debug qos

Configures the type of QoS events that will be displayed in the QoS log.
debug qos [info] [config] [rule] [main] [route] [hre] [port] [msg] [sl] [ioctl] [mem] [cam] [mapper]
[flows] [queue] [slot] [l2] [l3] [classifier] [nat] [sem] [pm] [ingress] [egress] [rsvp] [balance] [nimsg]
debug no qos
debug no qos [info] [config] [rule] [main] [route] [hre] [port] [msg] [sl] [ioctl] [mem] [cam] [mapper]
[flows] [queue] [slot] [l2] [l3] [classifier] [nat] [sem] [pm] [ingress] [egress] [rsvp] [balance] [nimsg]
Syntax Definitions
flows
queue
rule
l2
l3
nat
port
msg
classifier
info
config
main
route
hre
sl
mem
cam
mapper
slot
sem
pm
ingress
page 38-24
Logs events for flows on the switch.
Logs events for queues created and destroyed on the switch.
Logs events for rules configured on the switch.
Logs Layer 2 QoS events on the switch.
Logs Layer 3 QoS events on the switch.
Logs events for Network Address Translation policies. Not supported
for the OmniSwitch 6624/6648.
Logs events related to QoS ports.
Logs QoS messages.
Logs information whenever the switch classifies a flow; more details are
provided if the log level is higher.
Logs basic information about the switch
Logs information about the global configuration.
Logs information about basic program interfaces.
Logs information about routing.
Logs information about hardware route programming.
Logs information about source learning.
Logs information about memory.
Logs information about CAM operations.
Logs information about mapping queues.
Logs events related to slots.
Logs information about semaphore, process locking.
Logs events related to the Policy Manager.
Logs information about packets arriving on the switch.
OmniSwitch CLI Reference Guide
QoS Commands
November 2009