qos log level
Configures the level of log detail.
qos log level level
qos no log level
Syntax Definitions
level
Defaults
parameter
level
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the qos debug command to change the type of debugging messages that are logged. The qos log
level command configures the level of detail for these messages.
•
If the qos debug command is not configured to log any kind of information (this is the default), the qos
log level command has no effect.
•
To log fatal errors only, set the log level to 0.
•
Note that a high log level value will impact the performance of the switch.
Examples
-> qos log level 4
-> qos log level 0
Release History
Release 6.6.1; command was introduced.
page 38-12
The level of log detail, in the range from 2 (least detail) to 9 (most
detail).
default
6
OmniSwitch CLI Reference Guide
QoS Commands
November 2009