Sflow Sampler - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

sFlow Commands

sflow sampler

Gets the hardware sampled from Q-dispatcher and fills up the sampler part of the UDP datagram.
sflow sampler num portlist receiver receiver_index rate value sample-hdr-size size
no sflow sampler num portlist
Syntax Definitions
num
portlist
receiver_index
value
size
Defaults
parameter
receiver_index
value
size
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of this command to delete a sampler.
•
A sampling rate of 1 counts all packets. A sampling rate of 0 disables sampling.
Examples
-> sflow sampler 1 2/1-5 receiver 1 rate 1024
-> no sflow sampler 1 2/1-5
Release History
Release 6.6.1; command was introduced.
OmniSwitch 6250 CLI Reference Guide
Specifies the instance id.
Specifies the interface index range.
Specifies the receiver index.
Specifies the rate value for packet sampling.
Specifies the maximum number of bytes (size) that can be copied from a
sampled packet.
default
0
0
128
November 2009 page 37-5