Restoring Power To The Server; Verify That The Dal2 Card Is Installed Correctly; Disconnecting From The Standby Server; Connecting To The Active Server - Avaya S8 Series Manual

4. Replace all cable connections to the front and back panels of the server.

Restoring power to the server

To restore power to the server:
1. Apply power to the server by plugging the power cable into the socket on the back of the
server.

Verify that the DAL2 card is installed correctly

1. Connect to the server.
2. From the command line, run cat /proc/mdd.
The system responds with
The card memory is 512 MB if it sees the DAL2 card installed in the server.
!
CAUTION:
If the cat /proc/mdd command is performed on a pre 5.0 Communication
CAUTION:
Manager release, the command displays "This DAL-1 card STANDBY". The
output should be ignored if a DAL-2 card has been installed in preparation for the
5.0 upgrade. In release 5.0 and later, the output of cat /proc/mdd reports the
DAL-2 card.

Disconnecting from the standby server

Disconnect the laptop from the services port on the back of the server.

Connecting to the active server

To connect to the active server:
1. Connect to the service's port on the back of the active server.
Clearing the Web browser cache on the laptop
Issue 1 May 2009 161