If the server is a LSP
The procedures in this section are for S8300C or S8300D Server that function as a Local
Survivable Processor (LSP). If the S8300C or S8300D is not a LSP, omit this section and
continue with
Final replacement tasks
Stop and start Communication Manager
This synchronizes the main server's Communication Manager license for the LSP:
1. At the server command line type stop -caf and press Enter to stop the LSP/ESS
2. At the server command line type start -ca and press Enter to start the LSP/ESS
Save translations
To synchronize the main server's translations with the LSP:
1. Log in to the main server's SAT interface.
2. At the SAT prompt type save translation lsp and press Enter.
Look for "Success" in the Command Completion Status section.
3. Verify that the translations have synchronized with the LSP at the main server's SAT
interface by typing list survivable-processor and press Enter.
4. Ensure that this LSP server is listed and registered. Look for "Y" in the Reg(istered) column.
5. Logoff the system.
6. Release alarm suppression when prompted.
Note:
The time that it takes to synchronize the files with the LSP depends on the
Note:
system and network resources.
Final replacement tasks
Perform the following tasks to complete the server or hard drive replacement:
1. On the Server (Maintenance) Web page select Server > Status Summary and check the
overall health of the system.
on page 37.
If the server is a LSP
03-300528 Issue 6 May 2009
37