Remove And Replace A Dap (If A New Dap Is Available) - Avaya CS 1000 Fundamentals

Updating the DAP firmware
1. Start IP DECT Configurator.
2. In the IP DECT Configurator main window, click General.
3. If you have more than one DECT system configured in IP DECT Configurator, click
4. In the General Settings window click Browse.
5. Browse to the folder where the new firmware (the DAP package file) is stored, select
6. Click Apply.
7. Click Save system.
8. Click Activate/Deactivate/System status.
9. Ensure the DHCP and TFTP servers are running.
10. Click Reboot to restart the DAPs.
11. Enter the following URL in an internet browser: localhost/cds. The DAP Manager
12. In the Main panel, click Access Points. The Access Points page appears.
13. On the Access Points page, ensure the new firmware (Package ID) is uploaded

Remove and replace a DAP (if a new DAP is available)

Follow this procedure to remove and replace a DAP.
Replacing a DAP
1. Ensure that DAP Manager is running before you begin to replace a DAP.
2. Ensure that the DHCP server and the TFTP server are running in the IP network.
3. Open the DAP Manager Web interface.
4. Click Access Points.
5. Disconnect the DAP you need to replace.
6. Connect the new DAP.
SIP DECT Fundamentals
Modify, and select the system you want to update.
OR
If you have only one DECT system configured, proceed to step 4.
the DAP package file, and click Open.
The new firmware information appears in the DAP Package: field.
appears.
successfully.
Do not continue this procedure until DAP Manager indicates that the DAP is not
working.
Remove and replace a DAP (if a new DAP is available)
October 2012 151