Table of Contents
Advertisement
xStack® DGS-3620 Series Managed Switch Web UI Reference Guide
Loopback Interface Settings
This window is used to configure loopback interfaces. A loopback interface is a logical IP interface which is always
active, until a user disables or deletes it. It is independent of the state of any physical interfaces.
To view this window, click Management > IP Interface > Loopback Interfaces Settings, as show below:
The fields that can be configured are described below:
Parameter
Interface Name
Click the Find button to locate a specific entry based on the information entered.
Click the View All button to display all the existing entries.
Click the Add button to create a new entry.
Click the Delete All button to remove all the entries listed in the table.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specific entry.
Click the Add or Edit button to see the following window.
The fields that can be configured are described below:
Parameter
Interface Name
IPv4 Address
Subnet Mask
Interface Admin State
Click the Apply button to accept the changes made for each individual section.
Click the <<Back button to discard the changes made and return to the previous page.
Figure 3-14 Loopback Interface Settings
Description
Enter an interface name.
Figure 3-15 Loopback Interface Settings - Add/Edit window
Description
The name of the loopback interface.
NOTE: The loopback ipif has the same name domain space with the regular ipif, so
its name can't be a duplicate with the regular ipif.
Enter a 32-bit IPv4 address for the loopback interface.
Enter a subnet mask to be applied to the loopback interface.
Use the drop-down menu to enable or disable the loopback interface.
37
Advertisement
Table of Contents
