Batch Add Iax Extensions; Table 47: Batch Add Iax Extension Parameters - Grandstream Networks UCM6100 Series User Manual

Strategy
Skip Trunk A uth
Codec Preference
BATCH A DD I AX E XTENSIONS
Under Web GUI-­>PBX-­>Basic/Call Routes-­>Extensions, click on "Batch Add Extensions"-­>"Batch Add
IAX Extensions".
General
Start Extension
Create Number
Permission
Enable Voicemail
Firmware Version 1.0.9.26
detected and the received Fax will be sent to the Email address
configured for this extension. If no Email address can be found for the
user, the Fax will be sent to the default Email address configured in
Fax setting page under web UI-­>PBX-­>Internal Options-­>Fax/T.38.
This option controls how the extension can be used on devices within
different types of network.
Allow A ll
•
Device in any network can register this extension.
Local Subnet Only
•
Only the user in specific subnet can register this extension. Up to
three subnet addresses can be specified.
A Specific IP A ddress.
•
Only the device on the specific IP address can register this extension.
The default setting is "Allow A ll".
If enable "All", users do not need to enter password when making an
outbound call. If enable "Follow Me", the user can dial out via follow me
without password.
Select audio and video codec for the extension. The available codecs are:
PCMU, PCMA, GSM, AAL2-­G.726-­32, G.722, G.729, G.723, iLBC,
ADPCM, LPC10, H.264, H.263 and H.263p.
Table 47: Batch Add IAX Extension Parameters
Configure the starting extension number of the batch of extensions to be
added.
Specify the number of extensions to be added. The default setting is 5.
Assign permission level to the user. The available permissions are
"Internal", "Local", "National" and "International" from the lowest level to
the highest level. The default setting is "Internal".
Note:
Users need to have the same level as or higher level than an outbound
rule's privilege in order to make outbound calls from this rule.
Enable Voicemail for the user. The default setting is "Yes".
UCM6100 Series IP PBX User Manual Page 139 of 304