Concluding Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

14.5.5 Concluding steps

Ê Reconnect all remaining cables to the system board. For a complete cabling
overview, please refer to section
Ê Reinstall all remaining system board components as shown in the related
sections:
– Heat sinks: refer to section
– Memory modules: refer to section
page 539
I
Install all memory modules into their original slots.
– Expansion cards: refer to section
page 539
I
Install all expansion cards into their original slots.
– UFM board: refer to section
– TPM board (if applicable): refer to section
board" on page 773
Ê Reinstall all fan modules and fan holders as described in the related
sections:
– "Installing the system fan holder" on page 379
– "Installing system fan modules" on page 375
– "Installing the rear fan holder" on page 393
– "Installing rear fan modules" on page 381
Ê Reinstall the air duct as described in section
on page 94.
Ê Close the side / top cover as described in section
on page 107 (rack server) or
server).
Ê If applicable, activate TPM functionality in the system BIOS under Security >
TPM (Security Chip) Setting > Security Chip. For more information, refer to the
"D2949 BIOS Setup Utility for PRIMERGY TX300 S7 / RX350 S7 /
TX120 S3 Reference Manual".
TX300 S7 / RX350 S7
"Cabling overviews" on page
"Installing processor heat sinks" on page 588
"Installing the UFM board" on page 759
"Mounting the side cover" on page 114
Upgrade and Maintenance Manual
System board and components
"Installing a memory module" on
"Installing a memory module" on
section "Installing the TPM
"Installing the system air duct"
"Mounting the top cover"
851.
(tower
819