Figure 359: Closing socket release lever 1
Ê Close the socket release lever marked Open 1st (1) and latch it under the
load plate retention tab (2).
Ê If applicable, install the second processor accordingly.
11.2.4 Concluding steps
Perform the following procedures to complete the task:
Ê Install the processor heat sink onto the processor as described in section
"Installing processor heat sinks" on page
Ê Reinstall the air duct as described in section
on page
94.
Ê Close the side / top cover as described in section
on page 107
(rack server) or
server).
TX300 S7 / RX350 S7
"Mounting the side cover" on page 114
Upgrade and Maintenance Manual
588.
"Installing the system air duct"
"Mounting the top cover"
Processors
(tower
561