Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual page 460

Expansion cards and backup units
– The number of ECC Errors (4) has not greatly increased (beyond 100)
during a number of hours.
I
In order to reset the ECC error counter, enter the following
command: nvidia-smi [-p/-v] -g <GPUID>
Ê If one or more of the above conditions is not fulfilled, although sufficient
power supply has been assured as described in section
operation" on page
460
461, replace the GPGPU card.
Upgrade and Maintenance Manual
"Checking GPGPU
TX300 S7 / RX350 S7