Installing A New Fbu Module - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Figure 334: Removing the FBU from the FBU holder
Ê At a slight angle, slide the FBU from under the retaining brackets of the FBU
holder and remove it.
9.6.7.5

Installing a new FBU module

Ê Install the new FBU into the FBU holder as described in section
the FBU" on page
Ê Install the FBU holder into the chassis as described in section
FBU holder into the chassis" on page
Ê Connect the FBU to the controller.
TX300 S7 / RX350 S7
499.
Upgrade and Maintenance Manual
Expansion cards and backup units
501.
"Preparing
"Installing the
519