Removing An Accessible Drive; Installing An Accessible Drive; Concluding Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Accessible drives
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Open the side / top cover as described in section
on page 75 (rack server) or
server).
Ê Remove the air duct as described in section
on page 92.
Ê Remove the system fan holder as described in section
system fan holder" on page
I
Removing the front cover is not required in order to replace an accessible
drive.

12.4.3 Removing an accessible drive

Ê Remove all cables from the accessible drive.
Ê Remove the defective accessible drive as described in section
an accessible drive" on page

12.4.4 Installing an accessible drive

Ê Install the new accessible drive into the empty slot as described in section
"Installing an accessible drive" on page
Ê Reconnect all cables to their original accessible drive connectors as
described in section

12.4.5 Concluding steps

Perform the following procedures to complete the task:
Ê Reinstall the system fan holder as described in section
fan holder" on page
Ê Reinstall the air duct as described in section
on page 94.
626
"Removing the side cover" on page 84
378.
618.
"Cabling the accessible drive" on page
379.
Upgrade and Maintenance Manual
73.
"Removing the top cover"
"Removing the system air duct"
"Removing the
604.
"Installing the system
"Installing the system air duct"
TX300 S7 / RX350 S7
(tower
"Removing
609.