Removing The 2X 3.5-Inch Hdd Extension Box; Removing The Slimline Odd From The Hdd Extension Box; Removing The Lsd Module From The Hdd Extension Box; Installing The Slimline Odd Into The Hdd Extension Box - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Ê Remove the air duct as described in section
on page 92.
Ê Remove the system fan holder as described in section
system fan holder" on page
I
Removing the front cover is not required in order to replace the slimline
ODD or LSP in the 2x 3.5-inch HDD extension box.

12.6.3.3 Removing the 2x 3.5-inch HDD extension box

Ê Remove all cables from the 2x 3.5-inch HDD extension box backplane.
Ê Remove all cables from the slimline ODD.
Ê Remove the LSD cable from system board connector SMB 1.
Ê Remove the 2x 3.5-inch HDD extension box from the server as described in
section "Removing the 2x 3.5-inch HDD extension box" on page

12.6.3.4 Removing the slimline ODD from the HDD extension box

Ê Remove the defective slimline ODD from the 2x 3.5-inch HDD extension box
as described in section
on page 669.

12.6.3.5 Removing the LSD module from the HDD extension box

Ê Remove the defective LSD module from the 2x 3.5-inch HDD extension box
as described in section
on page 672.

12.6.3.6 Installing the slimline ODD into the HDD extension box

Ê Install the new the slimline ODD into the 2x 3.5-inch HDD extension box as
described in section
page 657.

12.6.3.7 Installing the LSD module into the HDD extension box

Ê Install the new LSD module into the 2x 3.5-inch HDD extension box as
described in section
on page 662.
TX300 S7 / RX350 S7
378.
"Removing the slimline ODD from the extension box"
"Removing the LSD module from the extension box"
"Installing the slimline ODD into the extension box" on
"Installing the LSD module into the HDD extension box"
Upgrade and Maintenance Manual
Accessible drives
"Removing the system air duct"
"Removing the
312.
677