Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

9.6.5.1

Required tools

Preliminary and concluding steps: tool-less
●
Removing a BBU: tool-less
●
9.6.5.2

Preliminary steps

Before removing an FBU, perform the following steps:
Ê Locate the defective server as described in section
server" on page
Ê Shut down the defective server as described in section
server" on page
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Open the side / top cover as described in section
on page 75 (rack server) or
server).
Ê Remove the air duct as described in section
on page 92.
Ê Remove the system fan holder as described in section
system fan holder" on page
TX300 S7 / RX350 S7
60.
67.
68.
"Extending the server out of the rack" on page
"Removing the side cover" on page 84
378.
Upgrade and Maintenance Manual
Expansion cards and backup units
"Locating the defective
"Disconnecting the server
73.
"Removing the top cover"
"Removing the system air duct"
"Removing the
"Shutting down the
72.
(tower
509