Accessible drives
12.7.2.2 Preliminary steps
Before removing a slimline ODD, perform the following steps:
Ê Remove all backup and optical disk media from backup and optical disk
drives as described in section
page
136.
Ê Shut down the server as described in section
page
67.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Open the side / top cover as described in section
on page 75
(rack server) or
server).
Ê Pull out the ID card and open the front cover as described in section
"Opening the server" on page
I
The front cover only needs to be removed in order to install
accessible drive dummy covers (see section
drive dummy covers" on page
reinstalled after removing the slimline ODD, skip this step.
Ê Remove the air duct as described in section
on page
92.
Ê Remove the system fan holder as described in section
system fan holder" on page
12.7.2.3 Removing the 4x 3.5-inch HDD extension box
Ê Remove the 4x 3.5-inch HDD extension box from installation bays 1, 2 and
3 as described in section
page
331.
690
"Removing backup and optical disk media" on
68.
"Extending the server out of the rack" on page
"Removing the side cover" on page 84
75.
378.
"Removing the 4x 3.5-inch HDD extension box" on
Upgrade and Maintenance Manual
"Shutting down the server" on
"Disconnecting the server
73.
"Removing the top cover"
"Installing accessible
622). If the HDD extension box will be
"Removing the system air duct"
72.
(tower
"Removing the
TX300 S7 / RX350 S7